![[PSI Home]](../images/circle4.gif)
![[Pointe Scientific, Inc.]](../images/psi-logo.gif){kind=logo}
![[Pointe 180]](../images/pointe180.jpg)
Pointe 180 Chemistry Analyzer
General Info
Features
Specifications
Test Menu
Ordering Information
Related Products
| Linear measurement range: |
0.00 to 2.50 Absorbance Units (A) |
| Photometric accuracy: | ± (1% of the reading + 0.005 A) at 1.5A ± (2% of the reading + 0.005 A) at 1.5-2A |
| Stability: | drift of no more than 0.005A in 8 hours/bichromatic |
| Light Source: | tungsten Halogen Lamp |
| Wavelengths: | 340, 380, 405, 490, 550, 600nm |
| Typical half bandpass: | 10nm |
| Type of filter: | Multiple-cavity sealed interference |
| Tube size: | 12mm round standard |
| Minimum fill volume: | 1 mL |
| Maximum fill volume: | 2 mL (for temperature control of 37° C only) |
| Temperature: | 37° C (± 0.3° ), Block stays on, Cell has on/off switch |
| Warm up times: | |
| lamp in rate mode | 120 seconds, built-in |
| lamp in Flow Cell mode | 240 seconds, built-in |
| lamp in other modes | 45 seconds, built-in |
| cell | 20-30 minutes (depends on ambient temp.) |
| incubation block | 20-30 minutes (depends on ambient temp.) |
| Lamp saver time: | after 15 minutes idle, 30 minutes in Flow Cell mode |
| Speed: | reads, calculates and prints results in 3 seconds |
| Display: | alphanumeric, 16 character, red, LED |
| Printer: | thermal, dot matrix, 20 characters per line |
| Keyboard: | 16 key, membrane switch, 4X4, audible response |
| Calculation Modes: | single point calibration by standard or factor, multipoint calibration with point to point curve fit, multipoint percent absorbance, rate by standard or factor (batch or singly), fixed time kinetic. |
| Fuse requirements: | 120VAC-0.6 A, 3AG slo blo |
| Power requirements: | 120 V or 240V AC, 50-60 Hz (switch selectable) |
| Enclosure: | painted flame retardant ABS Plastic cover with metal base |
| Dimensions: | 9.5 X 13.25 X 3.75 inches (24 X 34 X 10 cm) |
| Weight: | approximately 10 lbs. (4.5 Kg.) |
| Recommended operating temperature: | 18-35° C |
| Recommended operating humidity: | less than 85% |
| Optional Accessories: | Redi-Check® Photometer QA (for instrument QC) Aspiration Flow Cell Accessory |
Home | Company Information | Contact Us | Products | News
Ordering Information | Technical Support | Distributors
All information deemed reliable, but not guaranteed.