Pointe Scientific, Inc.

General Chemistry

Analyzers / Instruments

Standards / Calibrators

Quality Control / Quality Assurance

Instrument Specific Reagents

EIA

Urine Chemistry

OEM / Private Label / Custom Manufacturing

Liquid Stable Reagents

Consumables

Short-Dated Products

Pointe 180 SR
EIA Strip Reader

General Info
Specifications
Ordering Information

Photometric:
Linear measurement range:	0.00 to 3.0 Absorbance Units (A)
Photometric accuracy:	±(1% of the reading + 0.01 A) from 0 to 1.5A ±(2% of the reading + 0.01 A) at 1.5-3.0A
Stability:	drift of no more than 0.005A in 8 hours
Warm up Time:	45 seconds, built-in
Light Source:	Tungsten Lamp
Standard Wavelengths:	Standard: 405, 450, 492, and 630nm
Type of filter:	3-cavity hard coat interference filter, 10nm half bandpass typical
Vessel:	single, double or break apart strips, up to 12 wells long 3 strip load capacity
Electronic and Software:
Speed:	reads, calculates and prints results for up to 12 wells in about 30 seconds.
Display:	LED, 16 segment alphanumeric
Internal Printer:	thermal, dot matrix, 20 characters per line
Keyboard:	16 key, membrane switch, 4X4
Calculation Modes:	single point calibration, multipoint calibration with regression or point to point curve fit, cutoff, % Absorbance Multi-point, Uptake
Serial Port:	output only, 2400 Baud, 1 start bit, 8 data, 1 stop, no parity, no handshake
Power Source:	Switch selectable power supply (115V or 230V indicated) Voltage Source 110-120/220-240 VAC from 50 to 60 Hz, CAT II Power consumption is less than 50 Watts Fuse: two 1/2A, T rating, 250V All power cords must be approved for the country of use.
Enclosure:	ABS Plastic cover with metal base
Dimensions:	Approx. 9” X 12” X 3”, (23 X 30 X 8 cm)
Weight:	approx. 13 lbs. (5.9 Kg.)
Other:
Certifications & Compliances:	Listed to Standard UL 1262, Laboratory Equipment<br>CE Certificate of Conformity. Conforms to the following standards: EN 50082-1, EN 55022, En 61010-1 following the provisions of the 73/23/EEC and 89/336/EEC
Environmental Conditions for safe Operation:	Indoor use Altitude up to 2000m Temperature 5°C to 40°C (Although it may be safe to operate in these conditions, it may not be suitable for the performance of your tests; check with your supplier.) Humidity 80% for temperature up to 31°C, decreasing linearity to 50% humidity at 40°C Mains supply voltage fluctuations not to exceed ± 10% of nominal voltage.
Optional Accessories:	DRI-DYE Check Strips for instrument QC, replacement lamps, fuses, thermal paper, serial cable